- Product Details
Note: This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X (Requires a digital PM like PM02D).
Specifications:
Power Module Rated current:60A
Power Module Max current:120A(<60S)
UBEC output Current: 3A Max
UBEC Input Voltage: 7~42V(10S LiPo)
UBEC maximum power consumption: 18W
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g
Pin Map:
Make the PM06 show the quantity of electric charge of your battery
Mission Planner setup:
- Connect PM06 to the battery, also connect it to Mission Planner via USB.
- Click “INITIAL SETUP” and come to the menu “Battery Monitor”.
- Make “Monito” into “Analog Voltage and Current”.
- Make “Sensor” into “9: Holybro Pixhawk4 PM”.
- Make “HW Ver: "The Cube or Pixhawk" (pixhawk4,pixhawk4mini,pix32v5,pix32)”※
“HW Ver: Durandal(Durandal)”※ - Input “18.182” into Voltage divider (Calced).
- Input “36.364” into “Amperes per volt”.
- Disconnect and reconnect it to finish the setting up.(“Measured battery voltage” shows the current quantity of electric charge of the battery.)
※HW Ver: "The Cube or Pixhawk" (pixhawk4,pixhawk4mini,pix32v5,pix32)
※HW Ver: Durandal(Durandal).Or you can desigante it in the Full Parameter List
Package Include:
1x PM06 board
1x 80mm XT60 connector wire (installed)
1x Electrolytic capacito: 220uF 63V(installed)
1x JST GH 6pin cable
1x JST SH 6pin cable