HomeHome > Drone Peripherals > Power Modules & PDB

PM02D Power Module

Item Code:
15013
Digital Power Module This Power Module is compatible with Pixhawk® 5X & 6X.
Unit Price:
USD $24.00
Price:
USD
$24.00
Shipping Cost:
to
PC
  • Product Details
PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery,  as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S. The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.

It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Note: PM02D uses I2C digital signal data output and not compatible with Pixhawk 6C, Pixhawk4, Pixhawk4 Mini, pix32 v5, or Durandal flight controllers.


Spec

  • Input voltage: 2S - 6S
  • PCB Cont. Current Rating: 60A
  • PCB Burst Current Rating: 100A (<60 Sec)
  • Max current sensing: 164A
  • Voltage and current monitor with I2C compatible interface 
  • Outputs 5.2V and 3A max 
  • Weight: 20g

Current Rating:

The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference.


PIN MAP:

Package Includes

1x  PM02D Power Module
1x  6pin 2.00mm pitch cable