HomeHome > Drone Peripherals > Power Modules & PDB

PM06 V2-10S Power Module

Item Code:
15009
This Power Module is compatible with Pix32, Pix32 V5, Pixhawk4, Pixhawk4 mini, and Durandal. Not compatible with Pixhawk 5X.
Unit Price:
USD $15.00
Price:
USD
$15.00
Shipping Cost:
to
pc
  • Product Details
  • Write a Comment(0)
  • After-sales Service

Note: This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X (Requires a digital PM like PM02D). 

Specifications: 

Power Module Rated current:60A  
Power Module Max current:120A(<60S) 
UBEC output Current: 3A Max 
UBEC Input Voltage: 7~42V(10S LiPo)
UBEC maximum power consumption: 18W
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g

Pin Map:

Make the PM06 show the quantity of electric charge of your battery
Mission Planner setup:

  1. Connect PM06 to the battery, also connect it to Mission Planner via USB.
  2. Click “INITIAL SETUP” and come to the menu “Battery Monitor”.
  3. Make “Monito” into “Analog Voltage and Current”.
  4. Make “Sensor” into “9: Holybro Pixhawk4 PM”.
  5. Make “HW Ver: "The Cube or Pixhawk" (pixhawk4,pixhawk4mini,pix32v5,pix32)”  
            “HW Ver:  Durandal(Durandal)”           
  6. Input “18.182” into Voltage divider (Calced).
  7. Input “36.364” into “Amperes per volt”.
  8. Disconnect and reconnect it to finish the setting up.(“Measured battery voltage” shows the current quantity of electric charge of the battery.

HW Ver: "The Cube or Pixhawk" (pixhawk4,pixhawk4mini,pix32v5,pix32)

HW Ver:  Durandal(Durandal).Or you can desigante it in the Full Parameter List   

Package Include:

1x  PM06 board
1x  80mm XT60 connector wire (installed)
1x 
Electrolytic capacito: 220uF 63V(installed)
1x  JST GH 6pin cable
1x  JST SH 6pin cable

Quick Start Guide:

PM06 v2 Quick Start Guide