HomeHome > Peripherals > Power Distribution Boards(PDB)

Power Module(PM02 V3)

Item Code:
15010
Max input voltage: 51V/Max current sensing: 120A/Supports 12S battery The GH terminal is also compatible with both Pix32,Pixhawk4,Pixhawk4 mini and Durandal.
Unit Price:
USD $18.00
Price:
USD
$18.00
Shipping Cost:
to
pc
749 in Stock
  • Product Details
  • Write a Comment(0)
  • After-sales Service

PM02 is a simple way of providing your APM and Pix32 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from up to a 12S LiPo battery. The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.
The Power Module is designed to power APM,Pix32, a RC receiver and APM accessories (GPS, radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.
The GH terminal is also compatible with both Pix32,Pixhawk4,Pixhawk4 mini and Durandal.
 
Spec
UBEC input voltage : 7~51v (2~12s LiPo) 
Rated current:60A
Max current:120A(<60S)
Max current sensing: 120A
Supports 12S battery
Voltage and current measurement configured for 3.3V ADC 
Switching regulator outputs 5.2V and 3A max 
Weight: 20g


Make the PM02 show the quantity of electric charge of your battery

Mission Planner setup:

  1. Connect PM02 to the battery, also connect it to Mission Planner via USB.
  2. Click “INITIAL SETUP” and come to the menu “Battery Monitor”.
  3. Make “Monito” into “Analog Voltage and Current”.
  4. Make “Sensor” into “9: Holybro Pixhawk4 PM”.
  5. Make “HW Ver: "The Cube or Pixhawk" (pixhawk4,pixhawk4mini,pix32v5,pix32)”   
            “HW Ver:  Leave this blank(Durandal)”           
  6. Input “18.182” into Voltage divider (Calced).
  7. Input “36.364” into “Amperes per volt”.
  8. Disconnect and reconnect it to finish the setting up.(“Measured battery voltage” shows the current quantity of electric charge of the battery.)

HW Ver: "The Cube or Pixhawk" (pixhawk4,pixhawk4mini,pix32v5,pix32)

HW Ver:  Leave this blank(Durandal).Or you can desigante it in the Full Parameter List   
Command: BATT_CURR_PIN   Value: 17 
Command: BATT_VOLT_PIN   Value: 16

Package Includes:

1x   Power Module with XT60 Connectors Board
1x  Electrolytic capacito: 220uF 63V (installed)
1x   Molex 6 Position Connector 15 cm
1x   GH 6 Position Connector 15 cm 

Manual:

Holybro Power Module(PM02 V3) Manual