S500 V2 Kit（Motor:2216 880kv Propeller1045）,Multicopter kit

Product Details
Write a Comment(0)
After-sales Service

Product Description

The Pixhawk 4 S500 V2 Basic Kit is the perfect way to get started developing on Pixhawk 4 . It pairs a 480mm wheelbase frame and essential electronics with a Pixhawk 4 autopilot. The kit is easy to assemble.No soldering needed.
S500 V2 Update:1.Motor:2216 880kv; 2.Propeller 1045; 3.Motor mouts reinforced

Pixhawk4 S500 V2 KIT

Kit Contents

Pixhawk 4 autopilot（PM07 not included）
Power Management PM02（Assembled）
ARM adopts high strength plastics
Motors - 2216 KV880（ V2 Update）
Propeller 1045（ V2 Update）
Pixhawk4 GPS
Fully assembled Power Management Board with ESCs
433MHz Telemetry Radio / 915MHz Telemetry Radio
Power and Radio Cables
Battery Straps
Dimensions:383*385*240mm
Wheelbase:480mm
Weight:1330g

Note: No LiPo battery included.

Pixhawk4 mini S500 V2 KIT

Kit Contents

Pixhawk 4 mini autopilot（PM06 not included）
Power Management PM02（Assembled）
ARM adopts high strength plastics
Motors - 2216 KV880（ V2 Update）
Propeller 1045（ V2 Update）
Pixhawk4 GPS
Fully assembled Power Management Board with ESCs
433MHz Telemetry Radio / 915MHz Telemetry Radio
Power and Radio Cables
Battery Straps
Dimensions:383*385*240mm
Wheelbase:480mm
Weight:1320g

Note: No LiPo battery included.

Recommended Battery Specification: 4S 5000mAh Lipo
Max payload: up to 1.8kg (4S 5000 mAh battery)

Manual:

S500 V2 Kit_AssemblyManual

Maybe You Also Like...

Durandal

Durandal is a new flight controller designed by Holybro utilizing the STM32H7 microcontroller series.

$205.00

Pixhawk4 mini

Pixhawk 4 Mini was designed and developed in collaboration with Holybro® and Auterion®. It is based on the Pixhawk FMUv5 design standard and is optimized to run PX4 flight control software.

$139.00

SALE

Pixhawk 4

Pixhawk® 4 is the latest update to the successful family of Pixhawk flight controllers. It is designed and developed in collaboration with Holybro and Auterion, optimized to run PX4. It comes preinstalled with the latest PX4 firmware.

$170.00 ~~$170.00~~

Kakute F7 HDV Stacks

Holybro Kakute F7 HDV is designed to work with the DJI FPV VTx module. The GH port available on the board makes it much more convenient for you to connect Holybro Kakute F7 HDV to the DJI FPV VTx, for both signal and power supply.

$92.00